径向剪切干涉法综合诊断光束质量研究

 为了解决高功率激光装置光束质量诊断系统的自验证问题，研究了基于空间相位调制的径向剪切干涉法综合诊断光束质量的实验应用。该方法理论上只需一台干涉仪且从单幅干涉图中获取光束的近场、相位和远场分布信息。实验结果表明，目前可以得到高分辨率的相位分布，由测量近场和相位恢复出的远场同CCD直接测量得到的远场形态相同，环围能量比曲线相当吻合，不足之处在于只能提取近场较低空间频率成分，还达不到CCD直接测量的空间分辨水平。     

外加磁场微波等离子推力器内流场数值模拟

为了提高微波等离子推力器性能，改善等离子体对电磁波能量的吸收状况，提高核心区温度，提出外加磁场的方案，并对热等离子体进行了数值模拟.假设局域热平衡条件，采用Navier-Stokes，Maxwell和Saha方程，利用压力修正的半隐格式和时域有限差分求解方法，建立了径向磁镜场下推力器内等离子体流场的数值计算模型.数值模拟结果表明：外加磁场后的磁感应强度小于0.5 T时，推力器内热等离子体核心区最高温度随磁感应强度的增加而迅速提高.外加磁场后的磁感应强度大于0.5 T时，核心区最高温度随磁感应强度的增加而缓慢提高.磁感应强度为0.5 T时，热等离子体核心区最高温度与不加磁场相比提高了24%.外加磁场对等离子体流场速度分布影响不大. 关键词： 等离子体模拟 等离子体相互作用 等离子体流动     

On the Behavior of Some Second Order Nonlinear Differential Equations

Qualitative behavior of second order nonlinear differential equations of type y″+p(t)y+q(t)f(y)=0, is studied. It includes properties such as positivity, number of zeros, oscillating nature, boundedness and monotonicity of the solutions.     

Electrochemical impedance spectroscopy and linear polarization applied to evaluation of porosity of phosphate conversion coatings on electrogalvanized steels

In this work, electrochemical impedance spectroscopy and linear polarization are used in determining porosity of zinc phosphates, and of nickel and manganese modified zinc phosphates on electrogalvanized steel. The porosity of the phosphate layers ranges from 0.1% for the manganese-modified hopeite to 8% for hopeite, using the linear polarization and the electrochemical impedance spectroscopy techniques. The porosity values measured using the two techniques were in agreement. All impedance spectra of coated samples showed two steps, with two capacitive arcs and an inductive looping.     

关于不含k-C-圈的n阶r-一致超图的若干结果

主要讨论了不含k-C-圈的n阶r-一致超图,对不同的k,分别得出了它的极大边数的一个下界,并且得出在有些情况下它的下界是最大的.另外,我们得到了Krn含k-C-圈的一个充分必要条件.     

Measurement of surface topography by RGB Shadow-Moiré with direct phase demodulation

In this paper we present the application of a direct demodulation method for the measurement of surface topography by means of Shadow-Moiré. In our set-up, we use three LEDs (with green, red and blue peak wavelengths) to illuminate the grating. Due to the different position of these light sources, a polychromatic Shadow-Moiré fringe pattern is produced, which can be described as the superposition of three monochromatic (red, green and blue) fringe patterns. Taking the image of this polychromatic fringe pattern with a RGB CCD camera, we get a monochromatic fringe pattern stored at each RGB channel of the CCD. The direct demodulation algorithm employed uses these fringe patterns to calculate the wrapped phase map. After unwrapping the phase map using a standard multi-grid technique, we implemented an automatic procedure to detect the area of interest of the phase map by removing low modulation zones and to calculate the absolute value of the phase. In this way it is possible to determine the topography of a surface with a single RGB snapshot maintaining a simple experimental set-up, which is an important feature, especially for the study of dynamic phenomena such as deformations. We present the experimental results obtained after measuring different objects with both smooth and rough surface textures.     

The electrochemical reduction of perezone in the presence of benzoic acid in acetonitrile

An electrochemical study using transient techniques of a quinone-type natural product, perezone, has been performed in acetonitrile and in the presence of benzoic acid. Using linear sweep voltametry and single potential step chronoamperometry, it was possible to establish that the reduction mechanism of perezone involves a monoelectronic charge-transfer step, followed by a protonation step and homogeneous charge transfer due to disproportionation of the protonated intermediate. The mechanism for the homogeneous charge-transfer step was found to be of the type DISP1 (disproportionation order one) from the results of double potential step chronoamperometry experiments. The occurrence of the DISP1 mechanism was provoked by the mildly acidic medium used in this study.     

Improvement of the properties of polyarylate reinforced with liquid crystalline polymers

Blends of polyarylate of bisphenol A, PAr, with two commercial main chain liquid crystalline polymers, Vectra A950 and Vectra B950, are studied. From dynamic viscoelastic measurements it is deduced that both systems (PAr/Vectra A950 and PAr/Vectra B950) are immiscible and scanning electron microscopy (SEM) micrographs show the presence of spherical domains of the liquid crystalline polymer when PAr constitutes the matrix. Extrusion capillary measurements reveal that, under conditions of temperature and shear rate similar to those of processing, the viscosity is reduced to approximately 10% of its value when the content of liquid crystalline polymer is only 20%. This great improvement of the rheological properties is observed in both PAr/Vectra A950 and PAr/Vectra B950 blends. The effect of draw ratio on Young's modulus for different compositions is also analyzed, pointing out the reinforcing action of both liquid crystalline polymers on polyarylate: for instance, 20% of Vectra B950 in the blend gives rise to a 700% increase of the modulus of fibres prepared at a draw ratio of 50. SEM of the extrudates reveals that the spherical domains are elongated at the entrance of the capillary giving rise to a microfibrillar morphology which is related to the excellent rheological and mechanical properties of the blends.     

采用热处理方法提高MEH-PPV单层聚合物有机发光二极管发光性能的研究

对以MEH－PPV为发光层的单层聚合物有机发光二极管（OLED）器件在最佳条件下进行真空热处理，并用金相显微镜观察施加电压后器件的阴极表面形貌。发现处理后的器件阴极表面的气泡及黑斑明显减少。器件的发光性能显著提高。与未经处理的器件相比，最大相对发光强度提高了一个数量级、启亮电压降低了2．0V，半寿命提高了12．7倍。初步分析表明热处理方法提高器件发光性能的主要原因在于有效地减少了器件在工作过程中由于焦耳热产生的某些气体，从而减少阴极表面气泡及黑斑的出现，另一方面，热处理方法也增强了有机发光层与阴极接触界面的结合力，提高电子注入水平。     

Area orthogonality in normed linear spaces

A new concept of orthogonality in real normed linear spaces is introduced. Typical properties of orthogonality (homogeneity, symmetry, additivity, ...) and relations between this orthogonality and other known orthogonalities (Birkhoff, Boussouis, Unitary-Boussouis and Diminnie) are studied. In particular, some characterizations of inner product spaces are obtained.